Analisa Pengendalian Kualitas dengan Menggunakan Metode Six Sigma pada PT. BIntang Persada Satelit pada Tahun 2012

Abstract

With the concept definition phase of Six Sigma done (define), by way of defining standards of quality problems in the company's production process, Later stages of measurement (measure) calculated the value of Upper Control Limit (ucl-), Lower control Limit (LCL) and the calculation of DpMo and sigma at the highest cause of disability. In the analyze phase made the process of identiffing the causes of quality problems using pareto diagrams and cause and effect diagram. Next is doing improve with Six Sigma quality improvement should be measured, review the recommendations of improvement, corrective action performed to aur:milyze later. The last stage is the control, the quality improvement stage to ensure a new level of performance in standard conditions and maintained improvement values are then documented and disseminated usefrrl as measures of performance improvement for the next process. Linear regression analysis is used to detennine the effect of the production of defective products, which are used to predict the level of disability by the management company's products. By using Six Sigma methods can be seen that the quality produced by the company parabola quite well (located at the top level corporate Indonesia sigma) is2.4l Sigma. The high of 1.1A67% defective products should be suppressed, as evidenced by the lowest defect rate of 0.755502, meaning the company should be able to make the production process with a defect rate of 0.7555%. pT in the production process. Star Satellite Persada menetapakan do quality control with a maximum tolerance of 1% damage. Based on existing problems, third highest cause of defective products can be defined as follows: damage due to cutting error of 37.50Yo iron plate, mesh cutting error of 25 .21%, and a hollow aluminum cutting error of 17.29%.